Introduction
...
| Tip |
|---|
To see if a command is set to Direct or Interactive mode, look behind the command name. If there are ellipsis (...) behind the name, the command is set to Interactive mode. |
...
Commands can be stored in three categories:
...
| Panel | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
Change the color table on a seabed surface
|
Sticky Surface
Geocap has a concept where any surface can be set to be sticky. When a surface is sticky, data like points, lines or images may be displayed onto that surface. This is mainly done by re-sampling lines and displaying them a little bit above the sticky surface. When a surface is activated (or set) as a sticky surface, it is copied to workspace under the name sticky_surface. If this dataset is removed from workspace, there is no sticky surface anymore.
...