Introduction
...
| Panel |
|---|
| borderColor | #404040 |
|---|
| bgColor | #F0F0F0 |
|---|
| borderWidth | 1 |
|---|
| borderStyle | dashed |
|---|
| title | Exercise |
|---|
|
Change the color table on a seabed surfaceVisualize a seabed surface Click on the Color Tables tab in the Toolbox Click, drag and drop one of the color tables on the seabed surface
|
Sticky Surface
Geocap has a concept where any surface can be set to be sticky. When a surface is sticky, data like points, lines or images may be displayed onto that surface. This is mainly done by re-sampling lines and displaying them a little bit above the sticky surface. When a surface is activated (or set) as a sticky surface, it is copied to workspace under the name sticky_surface.
| Panel |
|---|
| borderColor | #404040 |
|---|
| bgColor | #F0F0F0 |
|---|
| borderWidth | 1 |
|---|
| borderStyle | dashed |
|---|
| title | Exercise |
|---|
|
Display data on the Sticky Surface- Right-click on a Seabed surface dataset and select
 Image Removed Set as sticky surface - Select a line, e.g. 1. Maritime lines > 200M lines > Baseline_Atlantis + 200M in your project.
- In the Toolbox under Commands > Schema commands right-click Display and click Edit.
- Check the Glue to Sticky Surface and press Execute.
- Investigate the line display
- Uncheck the Glue to Sticky Surface and press Execute again and observe the difference.
|
...