Versions Compared

Version Old Version 4 New Version 5
Changes made by

Erlend Kvinnesland

Erlend Kvinnesland

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width70%

Introduction

The tracking data is the foundation of all further GIM processing, such as generating surfaces and , 3D bodies and GIM seismic. It is therefore essential to be aware of how to set the GIM tracker tracking parameters to obtain optimal results.

Column
width30%



On this page:

Table of Contents

Tracking parameters

Testing tracking parameters

Wether the objective of the GIM tracking is to generate GIM seismic or GIM tracking to create GIM surfaces, it is essential to first set the tracking parameters optimally. Since the tracking process only takes a few seconds on any given inline/xline, or 2D section, it is possible to effectively test the tracker interactively until the desired result is obtained. To test the tracker parameters, make sure a seismic section is displayed in the Geocap graphical window, and then click Tools->GIM Data Generation->GIM Tracking.

Tracking the cube