Versions Compared

Old Version 34

changes.mady.by.user Erlend Kvinnesland

Saved on

compared with

New Version Current

changes.mady.by.user Erlend Kvinnesland

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width70%

Introduction

Digitizing is one of the most important ways the user can interact with Geocap to create new dataset. In contrast to typing in numbers in an editor, the digitizer gives the user the ability to interact with graphically displayed data.

Column
width30%



On In this pagesection:

Table of Contents

Quick digitizing

...

  1. Click Start digitizing and use the left mouse button to digitize.
  2. Click Connect to start if you want to close the polygon.
  3. Click Stop digitizing to save the line/polygon.

Tip

A digitized line is saved in the workspace by default. Use the Save digitized line also in folder option to save it directly in the project. Just tick the check box and browse in the folder you would like to save it to.

 

Digitizing in 3D

Quick digitizing operates in 2D mode by default and one can just click with the left button key to digitize. It is however possible to enter 3D mode and perform digitizing in 3D.

...

  • Move points
  • Change value of a point
  • Delete points
  • Select points
  • Digitize