Versions Compared

Old Version 8

changes.mady.by.user Former user

Saved on

compared with

New Version Current

changes.mady.by.user Erlend Kvinnesland

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width70%

Introduction

Images, except GeoTIFFs, are imported with no geospatial reference, which means that they will be displayed in origo if they are not geo-referenced first. Since your data most likely will not be located around origo, you need to geo-reference the image before displaying it. Read more about: Images and Georeferencing

Column
width30%



On In this pagesection:

Table of Contents

Displaying an image

...

Before you drape an image on to the terrain, make sure that the image is georeferenced and in the same projection as the terrain. Use the Map image on terrain command, which can be found in the Additional display folder. In the menu you will have to select which terrain the image should be draped on.

Displaying cross sections

You need to make sure that the image has been vertically calibrated before you display it. You can do this by looking at its Schema. If it is set to Vertical Calibrated Image you can display it by Note that georeferenced images also may be displayed embedded in a surface by the LOD Grid Display command.

Displaying a vertically calibrated image

Vertically calibrated images can be displayed using the regular Display command, presuming the image is of the type Vertical Calibrated Image (look at the Type column in your project). Read more about how to vertically calibrate an image

Displaying Well-log images