Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Panel
borderColor#404040
bgColor#F0F0F0
borderWidth1
titleExercise
borderStyledashed

Create a single cross section with random direction

  1. Clear your screen by clicking the icon
  2. Display one of the grids from your layer model
  3. Set Geocap in 3D mode
  4. In the graphics window place your cursor where you want the cross section to start and press y on your keyboard, then place your cursor where you want the cross section to end and press y on your keyboard.

    Note

    Note that only the last cursor position is shown as a red dot but Geocap will remember both.

  5. Right click the Cross section folder and select Perform cross sections > X direction cross section from cursor. It will display and save the cross section as crossdata_Xdirection in the Cross section folder.Right click the Cross section folder and select Perform cross sections > Y direction cross section from cursorCross section between two cursor positions. It will display and save the cross section as crossdata_Ydirection fromAtoB in the Cross section folder.
Your graphics screen should look similar to the image below
  1. .



Layer cube

Another option for fast cross sections is to generate a solid layer cube.

...