Versions Compared

Old Version 6

changes.mady.by.user Erlend Kvinnesland

Saved on

compared with

New Version 7

changes.mady.by.user Erlend Kvinnesland

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Create and display a layer model

 

Panel
borderColor#404040
bgColor#F0F0F0
borderWidth1
titleExercise
borderStyledashed

Create a layer model

  1. Create a Generic folder and set the schema to Layer Model.
  2. Copy all time grids into this folder and secure the correct ordering from top to bottom by naming them with a prefix number 01 02 03 ... etc.
  3. Right click your layer model and select Zoom to Folder on the time layer model and draw the window frame and axes.
  4. Display all the layers in random colors.
  5. Create a map command that display the color using color range from 1000 to 4200.

...

Panel
borderColor#404040
bgColor#F0F0F0
borderWidth1
titleExercise
borderStyledashed

Create a layer cube

  1. Create a new folder under 02_Time data called Cube
  2. Right click your layer model and select Zoom to Folder on the layer model to get the overall layer window.
  3. Right click your layer model folder and select Utilities > Cube generation of all layers
  4. Set the Grid Window to: xmin = -188000, xmax = -47500; ymin = 7864500, ymax = 7959000, zmin = 1000, zmax = 4200
  5. Set the cube grid increments to 500 500 20.
  6. In Result cube browse for the folder 02_Time data / Cube and click OK. The cube should now be stored in your project.
  7. Make sure Save in project has been selected and click Execute.

  8. Apply the Manipulator to display the layers in the cube in a fast way in all directions.

    Tip
    titleSetting cursor for cross section action
    • The manipulator is for a cube is activated by cube > Utilities > Manipulator cube display.
  9. Run the manipulator in all directions on the cube.
  10. Display a layer grid to verify that the cross sections from the cube have correct extensions.

 

7 

Panel
borderColor#404040
bgColor#F0F0F0
borderWidth1
titleExercise
borderStyledashed

Display cross sections from the layer cube

  1. In the folder 02_Time data / Cube right click cubegrid and select Utilities > Manipulator cube display
  2. In the menu that pops up check the Frame box and notice that a plane is displayed with a frame around it.
  3. Check the X radio button and notice that the X plane is displayed with a frame.
  4. Try to click inside the X plane and drag it in the X direction.

  5. Try to activate the Y plane and move this plane

    Tip
    titleSetting cursor for cross section action

    If you want to keep a cross section in one direction and create another one in the same direction just click Permanent map
    If you want to get rid of a cross section click on the icon on the toolbar and click on the cross section.

...