A layer model is a collection of grids which have the same grid position and resolution. These grids are collected into a layer folder which is of type Generic and has the Schema Layer model.
From a layer model it is possible to create cross section in order to study the interior of the model in an easy way.
Column
width
30%
Exercises:
Table of Contents
maxLevel
4
minLevel
4
...
Panel
borderColor
#404040
bgColor
#F0F0F0
borderWidth
1
title
Exercise
borderStyle
dashed
Create a single cross section in an arbitrary direction
Clear your screen by clicking the icon
Display one of the grids from your layer model
Set Geocap in 3D mode
In the graphics window place your cursor where you want the cross section to start and press y on your keyboard, then place your cursor where you want the cross section to end and press y on your keyboard.
Note
Note that only the last cursor position is shown as a red dot but Geocap will remember both.
Right click the Cross section folder and select Perform cross sections > Cross section between two cursor positions. It will display and save the cross section as crossdata_fromAtoB in the Cross section folder.