...
Example of importing SEG-Y 2D navigation
1. Scan file (1)
Unless you are very familiar with the SEG-Y file you are importing we always suggest you scan the file, by clicking the Scan button, to make sure that the settings are correct. The results of the scan can be observed by clicking on the Scan Results tab. The shot point-, X-, and Y ranges are reported. The Z (time) range is also reported but ignored in the final import (all Z's are set to 0 in the resulting dataset).
2. Check shot point byte position (2)
The default settings are usually correct. However, one of the more common adjustments is the shot point's byte position. This defaults to byte position 17-20 in the trace header. To find the correct byte position select the Trace header tab. Here you can view the SEG-Y file's headers trace by trace. The byte positions' values are continuously reported as you move through the file. There are buttons for going backwards, forwards, start and end of the file. By closely observing how the values change you should be able to determine the correct byte position. Use the Shot point, Byte pos. spinbox to set the appropriate byte position.
| Tip |
|---|
Shot points often appear in pairs, i.e. they change every other trace. |
3. Check scaler value (3)
Another common adjustment is for the Scaler - set by default to byte position 71-72. The scaler determines the multiplication factor for X and Y, so if these values are to high or to low, you can adjust the multiplication using the From file drop down box.
...