Highlight layer model folder and read the command Information about the layer model.
Activate the command Initialize the layer model into Workspace. The layer model grids are read into workspace for fast retrieval.
Info
title
Layer model grids
When the layer model grids are in workspace it is quick to perform cross sections and other calculation.
If a another layer model shall be studied just activate Initialize the layer model into Workspace on the new layer model.
Cross sections will be performed on the layer models grids in workspace.
Create a new Generic folder and give it the name Cross sections and set the schema to Cross sections. Cross section commands will now be visible on this folder.
Do on the cross section folder Display fence type cross section. It will display and the fence data is saved in the cross section folder.
Erase the screen and open the cross section folder perform on the fence data Vertical redisplay from cross section data.
Activate on the cross section folder Legend for cross section.
Try the other cross section commands.
Tip
title
Setting cursor for cross section action
When doeing cross sections it is smart to have the bottom layer displayed.
Place a cursor position on the bottom layer using key letter y when in 3D mode, or just click when in 2D mode.
Cross section between two cursor points: Set two cursor marks. geocap remember them even if only the latest is shown.
Section
Column
width
50%33%
Layers mapped with the same color range
Column
width
50%33%
Cross section study of the time layer model
Column
width
33%
Image Added Cross sections displayed from a cross section cube