...
| Panel |
|---|
| borderColor | #404040 |
|---|
| bgColor | #F0F0F0 |
|---|
| borderWidth | 1 |
|---|
| title | Exercise |
|---|
| borderStyle | dashed |
|---|
|
Create cross sections. - Highlight layer model folder and read the command Information about the layer model.
- Activate the command Initialize the layer model into Workspace. The layer model grids are read into workspace for fast retrieval.
| Info |
|---|
| - When the layer model grids are in workspace it is quick to perform cross sections and other calculation.
- If a another layer model shall be studied just activate Initialize the layer model into Workspace on the new layer model.
- Cross sections will be performed on the layer models grids in workspace.
|
- Create a new Generic folder and give it the name Cross sections and set the schema to Cross sections. Cross section commands will now be visible on this folder.
- Do on the cross section folder Display fence type cross section. It will display and the fence data is saved in the cross section folder.
- Erase the screen and open the cross section folder perform on the fence data Vertical redisplay from cross section data.
- Activate on the cross section folder Legend for cross section.
- Try the other cross section commands.
| Tip |
|---|
| title | Setting cursor for cross section action |
|---|
| - When doeing doing cross sections it is smart to have the bottom layer displayed.
- Place a cursor position on the bottom layer using key letter y when in 3D mode, or just click when in 2D mode.
- Cross section between two cursor points: Set two cursor marks. geocap remember them even if only the latest is shown.
|
|
Another option for fast cross sections is to generate a solid layer cube.
| Panel |
|---|
| borderColor | #404040 |
|---|
| bgColor | #F0F0F0 |
|---|
| borderWidth | 1 |
|---|
| title | Exercise |
|---|
| borderStyle | dashed |
|---|
|
Create a layer cube. - Use Zoom to Folder on the layer model to get the overall layer window.
- Highlight layer model folder and activate the command Cube generation of all layers.
- Click Use Active Window to set the cube window.
- Set the cube grid increments to 500 500 20 to get 282 x 190 x 20 grid nodes.
- Click Execute. The cube is saved in workspace cubegrid.
- Get the cube gid into the project under the Time folder and rename the cube to time_cubegrid.
- Apply the Manipulator to display the layers in the cube in a fast way in all directions.
| Tip |
|---|
| title | Setting cursor for cross section action |
|---|
| - The manipulator is for a cube is activated by cube > Utilities > Manipulator cube display.
|
- Run the manipulator in all directions on the cube.
|
| Section |
|---|
| Column |
|---|
| 
Layers mapped with the same color range
|
| Column |
|---|
|
Cross section study of the time layer model
|
| Column |
|---|
| Image Modified
Cross sections displayed from a cross section cube |
|