Versions Compared

Old Version 10

changes.mady.by.user Former user

Saved on

compared with

New Version 11

changes.mady.by.user Former user

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Panel
borderColor#404040
bgColor#F0F0F0
borderWidth1
titleExercise
borderStyledashed

Create cross sections.

  1. Highlight layer model folder and read the command Information about the layer model.
  2. Activate the command Initialize the layer model into Workspace. The layer model grids are read into workspace for fast retrieval.
    Info
    titleLayer model grids
    • When the layer model grids are in workspace it is quick to perform cross sections and other calculation.
    • If a another layer model shall be studied just activate Initialize the layer model into Workspace on the new layer model.
    • Cross sections will be performed on the layer models grids in workspace.
  3. Create a new Generic folder and give it the name Cross sections and set the schema to Cross sections. Cross section commands will now be visible on this folder.
  4. Do on the cross section folder Display fence type cross section. It will display and the fence data is saved in the cross section folder.
  5. Erase the screen and open the cross section folder perform on the fence data Vertical redisplay from cross section data.
  6. Activate on the cross section folder Legend for cross section.
  7. Try the other cross section commands.
    Tip
    titleSetting cursor for cross section action
    • When doing cross sections it is smart to have the bottom layer displayed.
    • Place a cursor position on the bottom layer using key letter y when in 3D mode, or just click when in 2D mode.
    • Cross section between two cursor points: Set two cursor marks. geocap remember them even if only the latest is shown.
Section
Column
width50%

Image Added
Layers mapped with the same color range

Column
width50%

Image Added
Cross section study of the time layer model

section
Section
Column
width60%

Another option for fast cross sections is to generate a solid layer cube.

Panel
borderColor#404040
bgColor#F0F0F0
borderWidth1
titleExercise
borderStyledashed

Create a layer cube.

  1. Use Zoom to Folder on the layer model to get the overall layer window.
  2. Highlight layer model folder and activate the command Cube generation of all layers.
  3. Click Use Active Window to set the cube window.
  4. Set the cube grid increments to 500 500 20 to get 282 x 190 x 20 grid nodes.
  5. Click Execute. The cube is saved in workspace cubegrid.
  6. Get the cube gid into the project under the Time folder and rename the cube to time_cubegrid.
  7. Apply the Manipulator to display the layers in the cube in a fast way in all directions.
    Tip
    titleSetting cursor for cross section action
    • The manipulator is for a cube is activated by cube > Utilities > Manipulator cube display.
  8. Run the manipulator in all directions on the cube.
  9. Display a layer grid to verify that the cross sections from the cube have correct extensions.
Column
width33%

Image Removed
Layers mapped with the same color range

Column
width33%

Image Removed
Cross section study of the time layer model

Column
width33%40%


Cross sections displayed from a layer cube