...
Test and tune the parameters to get the proper ridge points.
The Valleys tab
Will find those grids nodes that define a valley (which is the opposite of a ridge). The parameters are:
...
The result is saved as <chart name> / classification / valleys_'maskwidth'_'shallower angle'_'deeper angle'_'contour angle'.
To see all valley points set Slope angle towards shallower = 1, Slope angle towards deeper = 1 and Maximum contour angle = 180.
Test and tune the parameters to get the proper valley points.
The Results
After executing the point classification a dialog will pop up showing the result from the classifications. The report itself is saved in the project structure in the folder named Reports located in the same folder as the terrain surface. The report itself is named as YYYYMMDD Points Classification (the name of the executed command).
All reports from all runs will be saved in the Reports folder.