Shared Commands

Introduction

Download shared commands published on this page and import them by going to the Commands manager in the Toolbox, then right-click on the Shared commands / Schema commands or any subfolder to import them.

Harald's Shared Commands

For years this set of shared commands has been distributed. They are made and maintained by Harald Sund.

This is a set of commands that are not a part of the official Geocap release. Geocap is programmable, and it is possible to create your own commands. Single commands or folders with commands may be exported (right-click) and export to a file, then imported by another Geocap user. In the following paragraph you may download the commands I share with other Geocap users.

To get these commands:

1. Download these commands here (last update, September, 2nd 2013) and put them somewhere on your disk.

2. Open the toolbox (View > Toolbox), and import the shared commands (on top level preferably) by right-clicking the Shared Commands and Import.

Note that in order to run some of the line and gridding commands you will have to run the initialization command (one time only) in each Geocap session. This is the command "00. Activate Harald's Shared Commands" and it needs to be executed on a project item. It will pop up a brief explanation.

3. The above mentioned initialization is avoided by downloading this script and save it in your folder for startup scripts like this:

C:/Users/Harald/geocaprc-6.4/userscripts/startup/HS_Shared_commands_startup.tcl