Gridding and surface modeling.
Grid models are essential in modeling reservoirs. Good grid models require good input and well tuned algorithms.
In this exercise we will use as input seismic interpretation lines and closed stick faults. There are seven interpretation sets including the seabed. The reservoir has six horizons. The bottom five have fault lines as input while the top one don't use any faults.
Exercise
Grid a time surface from seismic interpretation and no faults.
- Display interpretation lines from 02_Time data > Interpretation lines > 02BasePliocene.
- Apply the command Simple points and lines gridding
- Click Update window to get the project window as the grid window.
- Set x and y increment to 500.
Grid window for Course B1
- xmin = -188000, xmax = -47500; ymin = 7864500, ymax = 7959000
- Using grid increment 500 gives as size of grid: number in rows: 282 , number in columns: 190
- It is a relatively small grid, but useful in a course and the size of the project is kept reasonable low.
- Use gridding algorithm Parabolic (default).
- Check in for *Use two steps gridding". Grid increment will be automatic calculated if blank.
- Set moving average as gridding algorithm for 1. step.
- Click Execute. The result will be written to the same folder.
- Click OK and save the panel with all parameters.
- Create a new folder for interpretation grids and cut/paste the result grid into this folder.
Grid menus using faults
- The grid menu when faults are included is Gridding points, lines and faults. This menu can also be used when there is no faults, but the one we used is a simpler alternative.
Seismic 2D sections and navigation lines
Detail of seismic and interpretatin lines
Exercise
Grid a time surface from seismic interpretation and closed stick faults.
- Display 02_Time data > Faults > 07SilurianFaultInt_Polygons. This is how the fault polygons comes from Kingdom. They must be edited.
- Use Edit points and lines to remove the blobs. See Case study - Gridding of seismic interpretation data with faults.
- The correct edited fault lines are in 02_Time data > Faults > CorrectedClosedFaults. Use this if you don't have time to complete the editing.
Tips when editing fault lines with _blobs_
- To remove the blobs just delete the two extra points in the blobs.
- Apply the command Gridding > Gridding points, lines and faults.
Seismic 2D sections and navigation lines
Detail of seismic and interpretatin lines