...
The Vessel configurations part shows the configurations for the actual project. If the project contains data from one multibram echosounder only, normally one configuration is necessary.
When clicking the name of a vessel configuration the corresponding Survey lines are shown below.
During the import of multibeam survey data, the configuration parameters from the echosounder is checked against existing vessel configurations. All parameters are checked, like the type of echo sounder, number of transmitters and receivers (single head, dual head), the mounting parameters for the echosounder and the motion sensor (offsets and rotations), content of datagrams (depth, range), etc. If any setting is different a new vessel configuration is created. This means that the operator can check the configurations to see if there are any changes during a survey.
The Survey lines part
See the path to the survey line.
When clicking the name of a vessel configuration above the corresponding survey lines are shown in the list.
By holding the cursor over a survey line name a dialog shows in which folder the survey line is located in the project.
One or more
Change the Vessel Configuration
The Edit Vessel Configuration dialog
...