Point Cloud Editor (Multibeam Editor)

In this section:

Introduction

The Point Cloud Editor (Multibeam Editor) is a tool for 3D editing of multibeam and pointcloud data. The editor works on all pointcloud data displayed in the 3D window. All editing of data is done by flagging, which means that all editing can be reverted later.

 

How to open the editor

The editor is opened from the Seafloor Main Menu. Click Edit and then click Point Cloud (Multibeam) Editor.

The editor can also be opened by right-clicking the Multibeam folder menu.

The editor can also be opened by clicking the Tools menu on top of Geocap.

 

The editor


The Point Cloud Editor dialog.

 

The editor consists of two button rows. The "Selection" buttons on top provides different methods to select which points you want to edit. The "Action" buttons at the bottom provides different actions for the selected points.

The selection buttons

Button

Shortcut key

Description

Documentation

 

 

Add to / Remove from selection

This combo box specifies if the selection buttons should add the selected points to the current selection, or remove the selected points from the current selection.

'R'

Rubber Band Select

Enters the rubberband select mode. This will allow the user to select/deselect points inside a square. This can be used in the display window in 3D mode, 2D mode, or in the cross section window.

'L'

Lasso Select

Enters the lasso select mode. This will allow the user to select/deselect points inside a square. This can be used in the display window in 3D mode, 2D mode, or in the cross section window.

 

Threshold Select

Select/Deselect all points shallower or deeper than a threshold.

 

Flag Select

Select/Deselect points that have a flag set.

 Expand selection to pingWorks with Multibeam Survey data only. First use one of the other tools to select points. Then click the this tool to select all the other points in the corresponding ping(s).

 

Clear Selection

Deselect all points.


The action buttons

Button

Shortcut key

Description

Documentation

<ctrl>+'z'

undo

Undo last action or selection.

<ctrl>+'y'

redo

Redo the action or selection that you have previously undone with the undo button

<delete>

Delete

Flag the selected points as deleted.

 

Undelete

Remove the deleted flag from the selected points.

 

set flag

Set userflag to selected points.

 remove flagRemove flag from selected points.
 

Extract selected points

Extract the selcted points and save in the project. Browse to the project folder and save the points as a Poly Data.

 

Edit selected

The selected points will become selectable. All other points are now not selectable. Use this to isolate the area you want to edit. When you perform further selections, points outside the edit area will not be selected by mistake.

 

Edit all

Will make all points selectable again.

Only visible points are selected with the selection buttons. The "Point flag visibility filter" make some points invisible (by default the deleted poitns). These points will not be selected. You can modify the point flag visibility filter to control which points you want to select. Another similar option is to un-toggle (and hide) datasets in the project you want to ignore, when you do a selection.